BattleMeshV3/NodeConfigScript/Babel

* this script uses opkg to download and install packages, be sure it has a gateway etc configured (look at the Zlan and adapt it to your need)


opkg update
opkg install kmod-ipv6
opkg install babeld

set -a

HOSTNAME="@PARAM1@"
WIRED_IP="@PARAM2@"
WIRELESS_IP="@PARAM3@"
CHANNEL="@PARAM4@"
CELL="@PARAM5@"

# setting wireless config
DEVICE=`uci get wireless.@wifi-iface[0].device`
uci delete wireless.$DEVICE.disabled
uci delete wireless.@wifi-iface[0].network
#uci delete wireless.@wifi-iface[0].rate

uci set wireless.$DEVICE.channel=$CHANNEL
uci set wireless.$DEVICE.hwmode=11g
uci set wireless.$DEVICE.txpower=20

uci set wireless.@wifi-iface[0].network=wlan
uci set wireless.@wifi-iface[0].ssid=wbm_babel
uci set wireless.@wifi-iface[0].encryption=none
uci set wireless.@wifi-iface[0].bssid=$CELL
uci set wireless.@wifi-iface[0].rate=54M
uci set wireless.@wifi-iface[0].bgscan=0
uci set wireless.@wifi-iface[0].bgscan=ahdemo

uci set network.wlan=interface
uci set network.wlan.proto=static
uci set network.wlan.ipaddr=$WIRELESS_IP
uci set network.wlan.netmask=255.255.255.0
uci commit wireless && wifi
uci commit network

#[edit] Configure the daemon
#
uci delete  babeld.wlan.ignore
uci commit babeld

#[edit] Enable the daemon
#
[ -f /etc/init.d/babeld ] && {
  /etc/init.d/babeld enable
  /etc/init.d/babeld start
} || { 
  echo " ERROR: babeld init script not found" 
  exit 1
}


#[edit] Disable the daemon
#
#[ -f /etc/init.d/babel ] && {
#  /etc/init.d/babeld stop
#  /etc/init.d/babeld disable
#}

reboot 
exit

The following should be put in /etc/babeld.conf. (Note that this could probably be done with uci -- merci Gabriel -- but I'm not sure how.)

redistribute local ip 10.10.42.0/24 allow
redistribute local ip fdba:1943:e753::/64 allow
redistribute local deny

in ip 10.10.42.0/24 allow
in ip fdba:1943:e753::/64 allow
in deny

BattleMeshV3/NodeConfigScript/Babel (last edited 2010-06-03 19:26:24 by 213)