= Flashing Station =
The tool used for the flashing procedure is [[http://dev.open-mesh.com/downloads/svn/ap51-flash/trunk/|ap51-flash]]. Several patches have been added to support a low-memory consumption mode as well as scripts for the OpenWRT package which allow running an ap51-flash daemon on every LAN port of an embedded device like the Dlink DIR-300 and flashing 4 devices at the same time. Further both flashing images from the RAM (up to 7MB for a Dlink flash router) or a seperate NFS server is possible (for the WBM3, the latter has been done).

Warning: It hasn't been tested extensively for such a flashing-battery for 20 nodes before. The WBM3 showed, that there are still some race conditions in the tool and scripts, which makes restarting single instances manually necessary from time to time.

== The Setup ==
{{{
SWITCH
|   |
|   |
|   \----- Debian PC, running a NFS server
|
\------(WAN-Port) 5x Dlink DIR-300
                        (LAN-Port)
                             |
                             \----- 4x Foneras
}}}

== NFS server configuration ==
aptitude install nfs-kernel-server nfs-common

'''/etc/exports''':
{{{
/srv/nfs/images/port1   192.168.2.0/24(ro)                                                                                                                   
/srv/nfs/images/port2   192.168.2.0/24(ro)                                                                                                                   
/srv/nfs/images/port3   192.168.2.0/24(ro)                                                                                                                   
/srv/nfs/images/port4   192.168.2.0/24(ro)
}}}

'''Symlinks to image file directories (ln -s ...)''':
{{{
ln -s /directory/to/image-files /srv/nfs/images/port1
ln -s /directory/to/image-files /srv/nfs/images/port2
ln -s /directory/to/image-files /srv/nfs/images/port3
ln -s /directory/to/image-files /srv/nfs/images/port4
}}}
Now you can exchange different images for flashing by exchanging the /srv/nfs/images/ folder containing the symlinks.

== Flash Router ==
For the WBM3, there've been some experimental patches been added to the [[http://dev.open-mesh.com/downloads/svn/ap51-flash/trunk/|ap51-flash]] tool. They are further reducing its RAM consumption on the one hand and to let ap51-flash exit only, if it detected a successful reboot of a newly flashed device (before you had to check manually if the 10min. for flashing a Fonera were over).

 * [[attachment:ap51-flash-update.patch|Patches for ap51-flash]] in OpenWRT's packages svn revision 21552
 * [[attachment:.config|OpenWRT Kamikaze .config file]] (minimal package selection) (copy to your kamikaze build dir)
 * [[attachment:files.tar.gz|uci-config files]] (extract to your kamikaze build dir)
''Note:'' Increase ip address on WAN (in /etc/config/network) for every other flash router connected to the same switch

Then build your OpenWRT flash router image(s) and flash it/them on your soon to be Flash-Router(s).

'''Access to flash router:''' telnet 192.168.2.x

'''Flashing status:''' cat /tmp/ap51-flash.log

----

''Happy flashing!''